Pitco F1 Error Code
P/N 60132703", "Jumper for Electric Operation SCB Roll out for Gas Operation J18
Source: 00088 SELVRF.pdf
Stop searching through PDFs. Our AI assistant on WhatsApp is trained on official Pitco documentation and can diagnose this fault code and guide you through the repair in minutes.
5-day free trial — no credit card required.
Other Pitco Error Codes
“Heat Failure”. This code is nine (9) flashes. - FOR VAT TEMPERATURES ABOVE SET
nine (9) flashes.
RIGH NOFILTEROPERATIONS DESCRIPTION DIGIT CODE NON HCODES 21 31 32 22 13 23 33 C
" with an enumeration of descriptions and corresponding codes. There are labeled
TX, SE14T, SE14TR" with the numbers "700329" and "Rev F" alongside.Rev 700329 SE
CONNECTTOP11 SHEET6 IFEQUIPPED CONNECTTOP12, 230VAC/50Hz IFEQUIPPED J11 240VAC/5
T1 ENTRANCE BOX FRAM 160VAPERAPPLIANCEPLUS BASKETLIFTOPTIONIFINSTALLED FROM J11
+ means the module is bad. New vs Old Module (both PN 60152001): - Old version:
the attempt. The flash codes and their meanings are as follows: · 1 flash: Ignit
2.5A TD"), and power supply units are drawn with labels indicating power ratings
-- CONDITION | POWER SW | POWER LED | HEAT DEM | HFB/FAULT | SIDE ON | HEAT DEM
" are also visible, marking specific points or switches in the schematic. Throug